Also, consistently use 'ch' for channel variables. This matches how we
consistently use sdi, devc, and so on all over the code-base.
This fixes parts of bug #259.
The name 'probe' (and thus 'probe group') is a relic from the times when
sigrok was mostly about logic analyzers. Nowadays we support a lot more
device types where 'probe' is not really a good term and 'channel' is
much better suited.
This fixes parts of bug #259.
Drivers interpreted the uint64 values to the SR_CONF_TRIGGER_SLOPE
configuration setting in different ways. In order to orthogonalize
the API, change the type of the setting to a string with the same
format as uses for logic probes.
The sample rate on the Hameg scopes changes depending on the number of channels
turned on and on the current timebase.
Update the sample rate if any of the above change.
The current vertical division setting (per channel) and the timebase are stored
as a floating point number. This is suboptimal since clients expect us to send
this information to them in form of a rational number.
Store only the index of the current setting since all the supported settings are
already stored inside of an array.
The DF_END packet was send out after all configured frames were fetched, but
devices may stop the acquisition at any point in time and an DF_END will not be
send out in this case.
Send the DF_END packet inside of acquisition_stop() so this can't happen.
The device is after a scan left open and clients that don't call unconditionally
dev_open() will never fetch the initial device state.
Close the device after the scan so clients know they need to open it.
Uwe Hermann
poljar (Damir Jelić)
Aurelien Jacobs
Daniel Elstner
Martin Ling
poljar (Damir Jelić)