- When fine-tuning, keep adjust to the original baseline length
- Enforce a minimum amplitude based on settings, DP gap and track width
- Use binary search to fine-tune amplitude if the length is not trivial
- Account for inequalities in balancing
- Don't add the meander if adding it with min. amplitude will make the
tuning worse
- Keep a distance after meandering end to prevent overlaps in DP
Fixes https://gitlab.com/kicad/code/kicad/issues/9267
Fixes https://gitlab.com/kicad/code/kicad/issues/1776
The hard coded value was too small for certain calculations. Better to
have a configurable value that is initially set to our error level to
allow for deviations that don't meet the visibility test for spikes.
These have become more apparent with Clipper2
The connection width checker uses morton codes to order elements. The
sort should be primarily morton-based but needs to be stable in order to
ensure that nextZ/prevZ elements are properly placed as the actual
next/prev elements in the list. Otherwise, hitting a fracture point
might make us skip in the wrong direction
Fixes https://gitlab.com/kicad/code/kicad/issues/12831
Fixes an issue with `wait_for_tasks()` and adds a lower-overhead
`push_loop` helper. We replace our usage of `parallelize_loop` with
`push_loop` as we didn't use the multi-future vector return and don't
need the extra overhead.
The undo will remove/re-add items to the view in order to update the
RTree. However, if we only clear caches at the end (in the OnModify
call), then the (stale) bbox caches are still used for the re-add
operation, and they end up at the wrong place in the RTree.
Fixes https://gitlab.com/kicad/code/kicad/issues/13048
The dialog allows a color selection for each dielectric layer.
However for a "dielectric" defined by more than one layer, the color was handled
only for the first layer, and not for the other sub-layers.
Using a large epsilon here to allow for sloppy drawing can cause
the algorithm to miss very short segments in a converted bezier.
So use an epsilon only large enough to cover for rouding errors in
the conversion.
Fixes https://gitlab.com/kicad/code/kicad/issues/12951
Errors may get thrown when the 3d models are loaded for missing search
paths. This triggers the idle event that makes assumptions about the
state of the dialog. We halt event handling until the ctor finishes.
Fixes https://gitlab.com/kicad/code/kicad/issues/12944
(cherry picked from commit be86e9f57f)
Missing nickname can throw when generating a timestamp, this should be
caught and prevent further work in the footprint loading (the entry does
not exist)
Fixes https://gitlab.com/kicad/code/kicad/issues/13029
Seth Hillbrand
Alex
Graham Keeth
Jeff Young
jean-pierre charras
Jon Evans
Mike Williams