There was a possible NULL dereference when executing tool_up even
though we should never hit it, we protect against bad files.
Also converts a couple untranslated error strings.
Put the cursor and pan control TOOL_ACTIONs in ACTION,
and refer to them in that way.
The handlers are currently identical in Pcbnew and Cvpcb,
and Gerbview (and all canvases) can benefit from them as well
if they are in libcommon. Also saves duplicated code.
Fixes: lp:1795855
* https://bugs.launchpad.net/kicad/+bug/1795855
Previously, the M and G00, G01, G02 and G03 commands were read, but nothing was actually done.
The current support is a bit rough, but it allows reading some drill files with routing commands.
Also updates the file menu IDs so that we can actually handle
more than 9 items in the file history.
Also adds configurable file history length to the other gerber
files (zip, drill and job).
Fixes: lp:1745729
* https://bugs.launchpad.net/kicad/+bug/1745729
Primary change is to replace most control/window borders with
AUI pane borders. We implement our own AUI border drawing
routine which avoids the ugly one-pixel white frames around
dark canvasses.
Also increases the signal-to-noise ratio of all the pane
creation code in the various frames.
... and GetMsgPanelInfo.
Step 4 in the g_UserUnit eradication effort.
Also removes a couple of conversion routines that were close
enough to extinction.
(cherry picked from commit c75da51)
This not only reduces the number of different mechanisms, but
will also reduce (yet again) the number of Clarify Selection
pop-ups (because the CLIENT_SELECTION_FILTER runs before the
pop-up, while SanitizePads ran after it).
Fixes: lp:1710451
* https://bugs.launchpad.net/kicad/+bug/1710451
(cherry picked from commit e50a993)
Step 1 of the g_UserUnit global eradication. This commit includes
basic hookup of hotkeys, units tool-buttons and grid dialogs.
(cherry picked from commit e0500ab)
Be consistent with order, formatting, etc.
Remove debug stuff such as zone timestamp and net code.
Clean up misleading pad messages.
(cherry picked from commit 2132109)
The main issue is the fact Excellon files have no coordinate fine format definition.
Only the units are defined.
Units are floating point numbers or integer numbers.
Integer numbers can be defined as 3.3 or 2.4 numbers (mm/inches)
However some files (altium drill files for instance) use an other notation.
This fix is a workaround to accept 2.x (inch) or 3.x (mm) notations.
Fixes: lp:1754121
https://bugs.launchpad.net/kicad/+bug/1754121
Fixes: lp:1782053
https://bugs.launchpad.net/kicad/+bug/1782053
In Cairo mode, this function uses already the alpha color value setting.
Now for low alpha values (usually they are low, as said in many GAL comments),
Cairo mode and OpenGL mode should have a similar look.
The SELECTION is a std::set. Numerical dereference of item n is O(n) as
the iterator is not random access. Therefore, a for loop using
numerical dereference is O(n!) and quickly slows.
We avoid this by storing items to remove separately while iterating and
then removing the items after we complete.
Fixes: lp:1692081
* https://bugs.launchpad.net/kicad/+bug/1692081
Maciej Suminski
Jeff Young
Seth Hillbrand
Tomasz Wlostowski
Nabeel Ahmad
jean-pierre charras
John Beard
Carsten Schoenert