* Fix a minor problem with wxFileDialog to open a file that no longer
exists in PCBNew.
* Make GerbView open file behavior the same as PCBNew.
* Remove redundant PCB file wild card definition.
* Add open file refactor task to the todo list.
* Fix some minor code formatting issues.
* Make USE_WX_ZOOM clipping routine actually clip rather than just test
if line needs drawn.
* Clean up as many USE_WX_ZOOM #ifdefs as possible.
* Minor coordinate rounding improvements.
* Minor scrolling and panning improvements.
* Remove unused KicadGraphicContext object code.
* Implement code to allow wxDC to handle coordinate conversions between
device and drawing units.
* Add build settings to enable wxGCDC for wxGraphicsContext testing.
* Remove wxAUI conditional build cruft as it is now required to build
Kicad.
* Fix scroll increment size regression to prevent jumping around the
zoom center position.
* Add find GDI+ cmake module for building on WXMSW when wxGraphicsContext
is enabled.
* Create single event handler for grid size events.
* Fix all frame windows to use new grid size event handler.
* Use offset relative to ID instead of ComboBox index to save last grid size.
* Move last grid size load/save setting into WinEDA_DrawFrame.
* Add equality and assignment operators the GRID_TYPE.
* Add current grid helper methods to BASE_SCREEN.
* Add GetPins helper to LIB_COMPONENT to replace GetNextPin where applicable.
* Add AppendMsgPanel helper to WinEDA_DrawFrame.
* Improve rounding for display of coordinates when millimeter units are selected.
* Split out application specific command IDs to prevent unnecessary rebuilding.
* Eliminate duplicate menu and tool bar command IDs.
* Split component library editor and viewer definitions to separate header files.
* More component library and document file merge code.
* A bunch of minor string readability and consistency fixes.
pads option.) Haven't fixed the via issue
(since I don't quite understand why it is doing this, nor does it occur in 100% of the cases), but now you can just
turn
off magnetic tracks when I desire to move vias by small increments. Magnetic tracks are on by default. Original
via complaint here:
http://tech.groups.yahoo.com/group/kicad-devel/message/1155
Also mostly gotten rid of the annoying "Unable to drag this segment: two collinear segments" error. Now, if two
(or more) segments are collinear, they are merged into one equivalent segment when you try to drag them while
maintaining slope. I can't imagine any cases where this would be a bad thing (and I have plenty of experience where
the error was not desired!). Note I say *mostly* because there still seem to be some length=1 (e.g. 0.003mm) segments
at the end of valid-length segments. I do not want to remove them because this would change the board layout, though
in a basically imperceptible way. We could maybe have an option to clean & remove these minimal-length segments, but
I worry that they serve to connect things slightly off grid & those things on-grid; also, removal may cause DRC
errors. It would be good if we could avoid their creation.(?)
Marco Serantoni
jean-pierre charras
Wayne Stambaugh
stambaughw