Adds QA checks to copper sliver tests. Adds the following checks:
- Dot product between two arms (quickly avoids checks for >90°)
- Checks the sliver is convex (area test)
- Eliminates minor slivers with angles that are approximately 0 and ones
with the opposite side width beneath a configurable level
- Updates Clipper2 to fix a couple of jagged edges on inflate
- Adds simplify during zone fill inflation to limit jaggies
Fixes https://gitlab.com/kicad/code/kicad/issues/14549
(cherry picked from commit f7f52d77e4)
In particular, when a CN_ITEM is freed set all its anchor's
item pointers to NULL. (The anchors have a separate
lifecycle due to being std::shared_ptrs.)
Hopefully fixes Sentry KICAD-KV.
(cherry picked from commit 0eac5c6748)
Our basic logic for whether we have a hole or an outline in a footprint
checks if there is copper pads outside of the closed edge. This misses
the case where the footprint is used to align multiple holes but has no
copper. Since we do not support multiple outlines in a board, we can
safely assume that multiple, closed edges in a footprint represent holes
and not outlines
Fixes https://gitlab.com/kicad/code/kicad/issues/14468
(cherry picked from commit 4b91c0c8ee)
- Ensure that critical paths (ERC/netlister) are fully-rechecked
- Handle symbol/pin distinction in change markers
- Fully connect hierarchical pins in one pass descending
(cherry picked from commit 6e8a5acc66)
Previously, almost all connectivity updates were full updates, meaning
that the entire connectivity graph would be rebuilt each time a change
was made to the schematic. This update modifies the update to only
correct the subgraphs that are directly affected by the change.
It uses the existing connection graph to find all affected subgraphs as
well as connections to the changes based on the visible schematic.
These elements are removed from the existing connectivity graph and
marked dirty. They then have a new connectivity graph built only around
their changes. The resulting graph is merged into the original.
Currently, this ability is behind an advanced config flag
`IncrementalConnectivity` while testing.
Fixes https://gitlab.com/kicad/code/kicad/issues/10846
Fixes https://gitlab.com/kicad/code/kicad/issues/1794
(cherry picked from commit a154571438)
The spacemouse driver, particularly on Mac, is extremely unstable and
causes crashes even when not being used. This places the interface
behind an advanced config flag to ensure that users can affirmatively
opt-in to the potential for crashes
(cherry picked from commit 2cd854af14)
1) Don't read libraries multiple times
2) VDMOS default is nchan if not specified
3) In the absence of a workbook default to LTSpice compatability
4) Don't attempt to write out a model line for a subckt; it never has
a baseModel
wxImage::Mirror() and wxImage::Rotate() transforms clear some parameters, especially
the PPI stored in the image. It creates bad size (bad ppi) when saving a BITMAP_BASE
in files.
These parameters are now restored after transform.
Seth Hillbrand
Jeff Young
jean-pierre charras
Mike Williams
Lucas Dumont
Wayne Stambaugh
Marek Roszko