This adds a check for contiguous board outlines to the DRC. It also
uses the calculated outline to ensure that traces are not crossing the
outlines.
Fixes: lp:1648055
* https://bugs.launchpad.net/kicad/+bug/1648055
Rather than duplicating the connectivity calculations in determining
whether a track is dangling, we utilize the current database to find the
number of connected items for an anchor item when feasible.
Multiple anchors such as tracks still need additional logic.
Fixes: lp:1805479
* https://bugs.launchpad.net/kicad/+bug/1805479
The client filter might add items in the case where locked pads are
filtered. We need to handle this case when requesting selection by
adding new items to the m_selection
Fixes: lp:1802686
* https://bugs.launchpad.net/kicad/+bug/1802686
When changing the track width, we need to allow that the track's route
will change based on DRC, so force a move without changing position.
Fixes: lp:1785057
* https://bugs.launchpad.net/kicad/+bug/1785057
When we draw a path, we usually want to close the path when clicking on
the end of another line. This uses grid helper to ensure this
progression happens as expected.
When updating the status of the ratsnest, we mark its target layer as
dirty to ensure the revised data are used to draw/clear the ratsnest
Fixes: lp:1800301
* https://bugs.launchpad.net/kicad/+bug/1800301
(cherry picked from commit 50eedcf0b3)
JP notes that there is an issue with comma-based decimal locales and the
SaveSelection that is addressed by having a LOCALE_IO call in a limited
block.
This changed the copy timing of the clipboard and the interaction with
KDE Klipper again. To address this, we isolate the clipboard open call
to the end of the routine and force a round-trip of the clipboard data
before exiting.
Klipper seems to poll at odd times. When we copy to wxTheClipboard
in one locale and Klipper extracts data in a different locale, it throws
an XError. We don't need the extra LOCALE_IO calls as Format() uses its
own LOCALE_IO setting.
Fixes: lp:1800648
* https://bugs.launchpad.net/kicad/+bug/1800648
The ratsnest layer needs to be always enabled in GAL rather than taken
from the board settings. This also adds a finalize handler to the
picker tool that allows a picker-caller to perform a specific action
when the picker tool exits. In this case, we use it to clear the local
ratsnest selections back to the default.
Fixes: lp:1800301
* https://bugs.launchpad.net/kicad/+bug/1800301
(cherry picked from commit c0d9b9ab81)
When the local ratsnest tool is used, it should toggle the state based
on the global ratsnest visibility. After changing state, the layer
cache is marked as well.
Possibly related to lp:1800301
(cherry picked from commit 22fbf30f22)
This parameter defines the working area (full page) size.
The fix is not perfect, because it does not take in account the page size.
However it is similar to the "old" initialization, before Eeschema GAL.
In Eeschema, a reasonable boundary size is used.
Distinguish between the snap-from and snap-to items. Previously, we
used the SELECTED or DRAGGED flags but the flagging arcitecture was
inherently fragile. This specifies items directly that should not be
used as snap targets.
Fixes: lp:1802795
* https://bugs.launchpad.net/kicad/+bug/1802795
jean-pierre charras
Seth Hillbrand
Jeff Young
Wayne Stambaugh
Maciej Suminski
nats