1) Don't reset value when name changes
2) Don't fire events when initialising dialog
3) Make sure when symbol is saved back to schematic that only current
instance has its ref updated, but that all instances have their other
fields updated.
4) When saving symbol back to board always use the fields from the
editor and not the (alias-specific) ones from the library.
Fixes https://gitlab.com/kicad/code/kicad/issues/8159
* Don't run the Ubuntu job on schedules
* Fix Coverity job by being explicit it is for schedules only
* Separate the caches for the Ubuntu and Fedora jobs
The thickness only needs to be computed when the actual
values change, so computing on UI update is a waste of
resources and can cause UI lag.
Fixes https://gitlab.com/kicad/code/kicad/issues/5049
When expanding an error to the outside of a rounded corner pad we
need to trim it to the pad bounding box or else we get little ears
where the circle approximation meets the pad square. This is expensive,
and for clearance lines we don't really care whether the error is
inside or outside.
Fixes https://gitlab.com/kicad/code/kicad/issues/8157
Instead of enabling/disabling the controls on every possible
UI event in these dialogs, only do it when the actual control
wants to know if it should change status.
This code was shared between the footprint frame and
pcb edit frame, so push it into the base edit frame.
Also remove the dummy wxUpdateUIEvents that weren't
actually being used.
We've been doing this for some time to wires that are attached to
the moving block (and therefore have the other end anchored). However
we also need to apply it when dragging a single end of a wire.
Fixes https://gitlab.com/kicad/code/kicad/issues/7807
This change is a bit more invasive than the description above would
suggest. UUIDs have been added to all schematics. For now, it's only
useful to the root schematic so that the UUID in the project file does
not change every time the project file is save. In the future, it may
be useful to store and check the schematic UUIDs against the one's saved
in the project file.
Fixes https://gitlab.com/kicad/code/kicad/issues/7763
Use the connecting straight tracks even if not exactly parallel - allow
an error margin configurable in ADVANCED_CFG (default 1 degree). Also
be less strict about end point matching and use the width of the track
as the criteria to determine suitability.
Finally, delete any short lengths of track at the end of the operation
and amend the arc end points to keep connectivity.
Fixes https://gitlab.com/kicad/code/kicad/-/issues/7967
Mikolaj Wielgus
Jonathan Haas
Jeff Young
Ian McInerney
jean-pierre charras
Jon Evans
Seth Hillbrand
Roberto Fernandez Bautista
Wayne Stambaugh