For legacy libs ans cadstar libs the extension is .lib.
So we need to read the header of the file, and therefore expand the env var inside
the filename, if used.
Adds QA checks to copper sliver tests. Adds the following checks:
- Dot product between two arms (quickly avoids checks for >90°)
- Checks the sliver is convex (area test)
- Eliminates minor slivers with angles that are approximately 0 and ones
with the opposite side width beneath a configurable level
- Updates Clipper2 to fix a couple of jagged edges on inflate
- Adds simplify during zone fill inflation to limit jaggies
Fixes https://gitlab.com/kicad/code/kicad/issues/14549
1) Don't read libraries multiple times
2) VDMOS default is nchan if not specified
3) In the absence of a workbook default to LTSpice compatability
4) Don't attempt to write out a model line for a subckt; it never has
a baseModel
wxImage::Mirror() and wxImage::Rotate() transforms clear some parameters, especially
the PPI stored in the image. It creates bad size (bad ppi) when saving a BITMAP_BASE
in files.
These parameters are now restored after transform.
in GetMsgPanelInfo() (PPI, scale).
m_image name was confusing: it is not a wxImage, but a BITMAP_BASE item,
and m_image name was already in use in BITMAP_BASE, used inside SCH_IMAGE.
Bitmap properties dialog: show PPI value and add Title to dialog.
- Ensure that critical paths (ERC/netlister) are fully-rechecked
- Handle symbol/pin distinction in change markers
- Fully connect hierarchical pins in one pass descending
Our basic logic for whether we have a hole or an outline in a footprint
checks if there is copper pads outside of the closed edge. This misses
the case where the footprint is used to align multiple holes but has no
copper. Since we do not support multiple outlines in a board, we can
safely assume that multiple, closed edges in a footprint represent holes
and not outlines
Fixes https://gitlab.com/kicad/code/kicad/issues/14468
Previously, almost all connectivity updates were full updates, meaning
that the entire connectivity graph would be rebuilt each time a change
was made to the schematic. This update modifies the update to only
correct the subgraphs that are directly affected by the change.
It uses the existing connection graph to find all affected subgraphs as
well as connections to the changes based on the visible schematic.
These elements are removed from the existing connectivity graph and
marked dirty. They then have a new connectivity graph built only around
their changes. The resulting graph is merged into the original.
Currently, this ability is behind an advanced config flag
`IncrementalConnectivity` while testing.
Fixes https://gitlab.com/kicad/code/kicad/issues/10846
Fixes https://gitlab.com/kicad/code/kicad/issues/1794
jean-pierre charras
Lucas Dumont
Jeff Young
Seth Hillbrand
Mark Roszko
Mike Williams