m_dragstatus is set to true when a valid route is created given the
user's constraints. We need to check this before committing the route
to the board.
Fixes: lp:1794810
* https://bugs.launchpad.net/kicad/+bug/1794810
Unselecting performs two functions: unselecting and unhighlighting.
Some items may be deselected but still live in the temporary highlighted
layer (e.g. selecting a footprint and exchanging it). Since there is no
harm in unselecting an unselected item, we can allow it to proceed
without the check.
* Renames /qa/common to /qa/qa_utils, as it is not to do with /common
* Renames /qa/geometry to /qa/common
* Put existing geometry tests into a subdirectory of /qa/common, to
echo the layout of the main tree.
The intention is to provide a place to put tests of other libcommon
code in the /qa/common suite.
Deselecting each individually had the side-effect of possibly re-drawing
the view in between actions, leading to visible artifacts in the router
(where invisible items are set visible before committing a change)
Nets dialog (Inspect->List Nets) contains list control
that has very small width for first and last columns.
Changed algorithm for calculating optimal values for
column width.
We only need to test zone connections once, so we skip the double-check
from the nested loop unless we are only checking a single zone. Then
the second loop needs to iterate over the full list of zones.
Commit efdbc91e42 broken the primary
alignment mechanism for maintaining the current point as an auxilliary
grid reference. This reverts that commit and fixes both the initial
issue and the associated bug by applying the primary constraint after
the secondary. In this way, we consider the secondary constraint as an
additive rather than alternative constraint.
Fixes: lp:1793888
* https://bugs.launchpad.net/kicad/+bug/1793888
Change "OK" to "Export" so user is not surprised by the fact that the
dialog does not close after the step file is created..
Fixes lp:1784260
https://bugs.launchpad.net/kicad/+bug/1784260
Somewhere during v5 rc cycle, the trimming of wires laid over simple
components was removed. The wires were still removed as soon as the
user moved the component again. This corrects the first behavior to
intended action for simple components.
Fixes: lp:1794019
* https://bugs.launchpad.net/kicad/+bug/1794019
(cherry picked from commit 9831a14ef3)
Reset lock file when saving a schematic sheet to a different file name.
This prevents a file is already open error from being displayed when
opening the original file.
Fixes lp:1788507
https://bugs.launchpad.net/kicad/+bug/1788507
It can be used instead of the slot (G85) command to create oval holes.
Do not yet activate it.
Oval holes frequently create issues with board houses.
Using a more usual routing (G01) command could solve some issues.
Previously, the M and G00, G01, G02 and G03 commands were read, but nothing was actually done.
The current support is a bit rough, but it allows reading some drill files with routing commands.
Jeff Young
Seth Hillbrand
jean-pierre charras
John Beard
Wayne Stambaugh
Baranovskiy Konstantin
Simon Richter
Tomasz Włostowski