Zone connections (even half-connections) should trigger the connected
logic in flashPads. This removes the double-standard for painting pads
and imposes thermal standoff based on the net connection to the pad if
it shares a net, not just if connected
New strategy is to draw the hole wall cylinder if the pad (or via)
isn't flashed on a particular layer. This is (1) more correct,
(2) keeps pads which aren't flashed on any layer from disappearing,
and (3) allows us to remove a bunch of the other special cases.
Or at least I think it does. The proof will be in the (lack of)
follow-on bug reports....
Also fixes a bug where via annular rings weren't highlighted in
high contrast mode.
Fixes https://gitlab.com/kicad/code/kicad/issues/7279
ADDED a new pin electrical type "free" for internally unconnected pins.
CHANGED the "unconnected" pin electrical type is now represented by
"no_connect" in files and netlists. (The legacy syntax is also accepted
in files.)
We cannot draw degenerate polygons, so we need to test for 0-size shapes
especially after scaling the mask. The mask adjustment is from both
sides however, so it needs to be doubled.
Fixes https://gitlab.com/kicad/code/kicad/issues/7020
(Surprisingly we used to in 5.1, so this is a regression.)
Also had to go back to the nag dialog as on a small screen the infobar
comes up behind the dialog. A lot of the errors have also been turned
into warnings, so the overall effect should still be to reduce nagging.
Fixes https://gitlab.com/kicad/code/kicad/issues/6992
High contrast should not show the annular rings from other layers. Once
the ring is removed, we hide the annular when not focused on a flashed
layer
Fixes https://gitlab.com/kicad/code/kicad/issues/6896
Also improves the pad warning and error messages, and moves a few
remaining nags from the setting infrastructure to the warning
infrastructure.
Fixes https://gitlab.com/kicad/code/kicad/issues/6141
For copper layers, if the pad shape is not on the active layer, only the hole
shape clearance is shown (this is correct).
But for non copper layers using the hole shape clearance make no sense
(as long as showing the clearance makes sense for some layers).
1) Make sure that layer dependencies don't prevent us from drawing
drill marks.
2) Don't draw pad shapes when their particular layer isn't enabled
(a side effect from the above)
3) Allow the printout painter to set a different hole colour (the
special case for through-hole pads was handled twice anyway -- once
in LoadColors() and once in draw( D_PAD ).
4) Replace the call to getDrillSize() which handles swapping in the
small mark size if set.
Fixes https://gitlab.com/kicad/code/kicad/issues/4847
Correctly hide netnames in high contrast mode
Correct highlighting for blind/buried/micro via drills
Repaint vias when needed to support stacked microvias
Fixes https://gitlab.com/kicad/code/kicad/-/issues/2593
Jeff Young
Seth Hillbrand
Jon Evans
jean-pierre charras
Marek Roszko