This patch introduces a new command, "connect_srst [enable|disable]"
which allows to enable special mode in which SRST would be pulled low
before the SWD scan till attaching to a target.
Since on Cortex-Mx the SRST signal doesn't gate JTAG and SWD, it's
possible to connect to a target while holding reset, ask it to stop at
reset vector and only then deassert reset, thus allowing to attach to
the kind of firmware that goes immediately to sleep or disables
debugging by other means early on start.
Tested on an STM32VLDiscovery board with STM32F100 configured to go to
STOP mode and executing WFI in the very beginning of main().
Signed-off-by: Paul Fertser <fercerpav@gmail.com>
This doesn't work with vanilla gdb, as for reasons unknown said vanilla gdb doesn't support XML target descriptions queried from the remote.
Add code to the fault unwinder to deal with the stack alignment fixup and FP registers. Avoid saving/restoring registers that don't get trashed.
Richard Eoin Meadows
Mike
Gareth McMullin
Gareth McMullin
Paul Fertser
Vegard Storheil Eriksen
Mike Smith