- Remove connect_assert_srst global.
- Attach functions always release reset.
- Platforms provide a method to poll the reset pin.
- Reset on scan is all internal to command.c
- Reset is released on a failed scan. Fixes#111
Some devices can get a significant boost in performance by writing to
flash memories one page at a time. Generic function to do this are
provided at the target layer and may be used by flash drivers.
Target support for stm32l0's and stm32l1's including option bytes and
data EEPROM. This module will superceed the previous stm32l1 driver.
o Program flash write and erase.
o Options modification and interpretive status.
o Stubs for program flash writes and erases. Stubs are modestly
faster than non-stub version. The stm32l0 will not execute stubs
when the MCU has crashed. A monitor option may be used to force
non-stub flash writes.
o Stubs generated from C++ code and converted to arrays of half-words.
o Writes to data EEPROM supoprted when loading segments.
o EEPROM data monitor command to write words.
o Stubs supported on stm32l1.
All source files include general.h first and before anything else.
This inlcludes platform.h and platform_support.h
No header file needs to include to include any of these, but should include
any others needed for it's own declarations.
This patch introduces a new command, "connect_srst [enable|disable]"
which allows to enable special mode in which SRST would be pulled low
before the SWD scan till attaching to a target.
Since on Cortex-Mx the SRST signal doesn't gate JTAG and SWD, it's
possible to connect to a target while holding reset, ask it to stop at
reset vector and only then deassert reset, thus allowing to attach to
the kind of firmware that goes immediately to sleep or disables
debugging by other means early on start.
Tested on an STM32VLDiscovery board with STM32F100 configured to go to
STOP mode and executing WFI in the very beginning of main().
Signed-off-by: Paul Fertser <fercerpav@gmail.com>
This doesn't work with vanilla gdb, as for reasons unknown said vanilla gdb doesn't support XML target descriptions queried from the remote.
Add code to the fault unwinder to deal with the stack alignment fixup and FP registers. Avoid saving/restoring registers that don't get trashed.
Gareth McMullin
David Lawrence
Richard Meadows
Uwe Bonnes
Marc Singer
Vegard Storheil Eriksen
Mike
Gareth McMullin
Paul Fertser
Mike Smith